Getting ready for your machine.

Every new machine is installed by a Lawazen engineer, with operator training included. Read the site preparation guide for your model below: it sets out what the machine needs from the room, the power supply and the extraction. If anything in it is unclear, send us a photo of the room on WhatsApp and we will go through it with you.

• The room, the route in and the power supply checked against the guide.
• A plan for where the extraction hose runs and where the air goes.
• The computer that will run the laser software, on your network.
• The people who will use the machine, free for the training.

Ruby is Trotec's laser software. It does not run every Trotec machine, so ask us before installing it for a SpeedMarker, a U series or a Rayjet.

• Machines without a screen on the machine: install Ruby from Trotec's Ruby help site and follow its installation steps.
• Speedy machines with a screen on the machine: a certificate is installed first. The Ruby videos in the help centre show each step.